Hi all, (Sorry for being late that I reviewed this draft with a printed one on my flight to home last month, however, I left paper there…) I have reviewed draft-ietf-dime-agent-overload-08 as part of the Operational directorate's ongoing effort to review all IETF documents being processed by the IESG. These comments were written with the intent of improving the operational aspects of the IETF drafts. Comments that are not addressed in last call may be included in AD reviews during the IESG review. Document editors and WG chairs should treat these comments just like any other last call comments. “This specification documents an extension to RFC 7683 (Diameter Overload Indication Conveyance (DOIC)) base solution. The extension defines the Peer overload report type. The initial use case for the Peer report is the handling of occurrences of overload of a Diameter agent.” My overall view of the document is 'Ready with nits' for publication. ** Technical ** No. ** Editorial ** *Section 2, page 4 > A RFC6733 Diameter Client, an RFC6733 Diameter Server, and RFC6733 > Diameter Agent. s/ RFC6733/ [RFC6733] Similar changes should also be made in this section to get consistent with section 1 and the last sentence in section 2(therein you were using [RFC6733]). * Section 3.1.1, page 4: > +-+ +-+ +-+ > |c|----|a|----|s| > +-+ +-+ +-+ Though I can easily guess what does “c, a, s” mean here, I still suggest to put full words or at least add a sentence below the figure to explain. The same issue should be fixed in all the figures below in entire section 3. * Section 3.1.2, page 6: > In the case where one of the agents in the above scenario becomes > overloaded s/ scenario becomes/ scenarios become If I understand correctly , here you were referring to two scenarios above? > When the client has an active and a standby connection to the two > agents then an alternative strategy for responding to an overload > report from an agent is to change to standby connection to active and > route all traffic through the new active connection. I would suggest to split this sentence in case of misunderstanding. * Section 3.1.3, page 7: > Handling of overload of one or both of agents a11 or a12 in this case > is equivalent to that discussed in section 2.2. Tried hard to find section 2.2, but there is no such section. * Section 5.1.1, page 8: > When sending a Diameter request a DOIC node that supports the > OC_PEER_REPORT feature MUST include in the OC-Supported-Features AVP > an OC-Feature-Vector AVP with the OC_PEER_REPORT bit set. Full name of AVP should be put into terminology.